| Form Factor | 19" Rackmount |
| Signal Path | Passive Hardware |
| Dimensions | 483mm x 510mm x 88mm |
| Weight | 12 Kg |
| Power | 185V-240V AC |
| Frequency Response | 20Hz - 20kHz ±0.5dB |
| Gain | 32dB |
| THD | Typical 0.05% @ 4Ohm, 1kHz THD+N |
| Indicators | signal green = -20dB, signal yellow = -3dB, red signal = clip, signal red protect = over current, low AC mains or 3 sec. mute on power up |
| Load Protection | DC on output, side chain TCA clip limiter circuit |
| Amplifier Protection | Short circuit, current overload, thermal shutdown, high frequency stability circuit |
| Audio Signal Inputs | Balanced Neutrik® Female XLR input connected Pin 1 - GND, Pin 2 - Hot, Pin 3 - Cold, XLR Male signal |
| Audio Signal Outputs | Neutrik® speakON each channel. Channels 1 & 3 output speakON utilises 2+ and 2- connection to allow use of 4 core loudspeaker cable for bi amp loudspeaker system, for example stage monitor system. |
| Links | Funktion-One Site |
| Notes | F Series amplifiers are made for Funktion One by English amplifier designers and manufacturers Full Fat Audio (FFA). The three amplifiers in the range are the excellent high power F100-2 dual power supply amplifier (suited to driving 4 x 8 Ohm 21" drivers per channel at 2 Ohms) and two four-channel amplifiers (the F40Q and F60Q). The 4 channel amplifiers are very useful for a wide variety of applications. All three amplifiers utilise rugged switch modulation power supplies (SMPS) with Class D Pulse Width Modulation amplifier stages.
Optional pre-set internal crossover cards can be ordered for specific multi-way applications as required. The card preset specification includes bandpass crossover, relative gain, limiter and time alignment of low frequencies for all channels as well as a mono sum bass option. (It is not currently possible to time delay mid-high frequencies). |
